STONETECH Professional Enhancer Pro 1 Qt. Size
Where to Use Natural stone such as marble, limestone, slate, travertine, sandstone, flagstone, tumbled stone, flamed stone & textured stone. Masonry & concrete.
Directions Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry, and free of waxes and coatings. Before application, surface should dry for 24-72 hours. Mask off baseboards or adjacent areas.
Liberally apply an even coat using a paint pad, low-pressure, solvent-resistant sprayer, roller or brush. Do not use a towel or sponge. Distribute Enhancer Pro evenly over entire surface. Uneven penetration will result in blotchy appearance.
Allow Enhancer Pro to penetrate surface for 15-20 minutes. Denser material may require more time to penetrate. Thoroughly wipe surface with dry cloth to remove all excess Enhancer Pro. DO NOT ALLOW ENHANCER PRO TO DRY ON SURFACE. Failure to remove Enhancer Pro from surface may result in residue that may need to be mechanically removed. A second coat may be needed for more absorbent surfaces. If darker appearance is required Enhancer Pro should be applied one hour after initial application, as directed in steps 2-4. Full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours.
Clean equipment with mineral spirits.
Size and Coverage Quart: 100 - 500 sq. ft Expected Wear: 3-5 years.