Where to Use Natural stone such as marble, limestone, slate, travertine, sandstone, flagstone, tumbled stone, flamed stone & textured stone. Masonry & concrete.

Directions Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry, and free of waxes and coatings. Before application, surface should dry for 24-72 hours. Mask off baseboards or adjacent areas.

Liberally apply an even coat using a paint pad, low-pressure, solvent-resistant sprayer, roller or brush. Do not use a towel or sponge. Distribute Enhancer Pro™ evenly over entire surface. Uneven penetration will result in blotchy appearance.

Allow Enhancer Pro™ to penetrate surface for 15-20 minutes. Denser material may require more time to penetrate. Thoroughly wipe surface with dry cloth to remove all excess Enhancer Pro™. DO NOT ALLOW ENHANCER PRO™ TO DRY ON SURFACE. Failure to remove Enhancer Pro™ from surface may result in residue that may need to be mechanically removed. A second coat may be needed for more absorbent surfaces. If darker appearance is required Enhancer Pro™ should be applied one hour after initial application, as directed in steps 2-4. Full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours.

Clean equipment with mineral spirits.