STONETECH Impregnator Pro. Quart

Features + Benefits: Heavy duty Stonecare protection against all stains Original fluorochemical technology Natural look Solvent-based, interior & exterior

Where to Use Natural stone such as marble, granite, limestone, slate, terrazzo, travertine & sandstone. Best suited for the most porous stone surfaces.

Directions Note: Directions may vary depending on size. Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings. Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated. Liberally apply an even coat using a paint pad, low-pressure solvent-resistant sprayer, roller or brush.

Allow sealer to penetrate the surface for 15-30 minutes; denser material may require more time for sealer to penetrate. During this time, distribute excess over entire area to insure even penetration. Thoroughly wipe the entire surface with a clean dry cloth to completely remove all excess Impregnator Pro™ from the surface. DO NOT ALLOW IMPREGNATOR PRO™ TO DRY ON THE SURFACE.

A second coat may be needed for porous, absorbent surfaces and should be applied one hour after initial application as directed in steps 2-3. If sealer was not completely wiped off and a residue appears, wipe entire surface with a towel dampened with sealer. Use a white nylon pad to loosen residue and follow with a clean, white absorbent towel to remove. A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. Cover with red rosin paper, if foot traffic must resume before the recommended time periods have passed.

Clean equipment with mineral spirits.

Size and Coverage: Quart 50-400 sq. ft.

Expected Wear: 3-5 years on interior surfaces & 1-3 years on exterior surfaces.